Rouleau de tuyau spiralé noir pour bassin

Yes, in most ponds, a 75 mm PE pipe can be replaced with a more flexible pipe of a larger diameter. But you need to compare the correct diameters, know whether the line is pumped or gravity-fed, and plan for suitable fittings. When done correctly, this change reduces pressure loss and can increase the actual flow rate of your pump.

Beware the diameter trap

PE pipe and pressure PVC are designated by their outside diameter: a "75" PE measures 75 mm on the outside, and its inside passage is smaller, depending on the wall thickness. Spiral hoses are often designated by their inside diameter. Glue-on flexible PVC indicates both: a 75 x 63 mm is 75 mm on the outside with a 63 mm passage.

To "make it bigger," therefore compare the inside diameters. Replacing a 75 PE with a 75 x 63 flexible gives a similar passage; a 90 x 75 mm flexible really offers more cross-section.

Why a larger diameter helps (on a pumped line)

At the same flow rate, water flows more slowly in a wider pipe: friction and therefore pressure loss decrease. Result: the pump works on a more favorable point of its curve and delivers more water at the outlet, often with the same consumption. Over long distances or with many elbows, the gain can be clearly visible.

However, the gain depends on the pump: if its outlet is 1½ inches, the discharge diameter already limits the flow. Enlarging the line remains useful, but does not turn a small pump into a big pump.

Gravity line: bigger is not always better

In a gravity system (bottom drain or skimmer to a filtration chamber), the diameter is fixed by the drain and the planned flow rate. An oversized line slows the water down too much: sludge settles in the pipe instead of reaching the pre-filter. In this case, keep the original diameter and favor a smooth-inside pipe.

Flexible, spiral, or flexible PVC: what to choose?

Type Strengths Limitations
Spiral PVC hose Very flexible, quick to install, connects to ribbed fittings Can be crushed if buried without protection; limited diameters
Glue-on flexible PVC Flexible, glues to pressure PVC fittings, ideal for underground Careful gluing is mandatory; bending radius must be respected
PE pipe Robust, resists frost and impacts well Rigid, wide elbows, specific compression fittings

For an underground line, glue-on flexible PVC is often the best compromise: it follows the terrain, accepts standard PVC fittings and does not crush like a light spiral hose. For a visible and removable connection near the filter, a spiral hose on a ribbed fitting remains very practical.

Connecting the old and the new

  • To switch from PE to PVC, use a suitable transition fitting (compression on the PE side, glue on the PVC side).
  • To connect two different diameters without glue, a flexible rubber reduction sleeve with stainless steel clamps does the job. The Flex Connector 90 mm connects two tubes of the same diameter.
  • On a ribbed fitting, install two offset stainless steel clamps.
  • Limit the number of elbows and prefer wide curves: every tight elbow costs flow.

Find the parts in the PVC/PE parts and flexible rubber fittings aisles.

Before you start

  1. Measure the outside diameter of the current tube and note the pump outlet and filter inlet.
  2. Identify the circuit: pumped (discharge) or gravity (drain, skimmer).
  3. Measure the length, the height to overcome and count the elbows.
  4. Choose a hose suitable for installation (underground or visible) and the transition fittings.
  5. After the work, check the tightness and the flow at the filter return.
The safest way: bring a piece of your PE tube or the current fitting to the Nodebais Aquiflor store. We measure, find the right transition and check the diameter with your pump curve, so you don't have to make the trip twice.

Frequently Asked Questions

Does a bigger hose increase the flow rate?

On a pumped line, generally yes: pressure losses decrease and the pump delivers more. The gain depends on the length, the elbows and the pump outlet.

Is the diameter of a 75 PE tube inside or outside?

Outside. The inside passage is smaller and depends on the wall thickness. Always compare the inside diameters.

Can you bury a spiral hose?

It is possible for short lengths that are well protected, but it can be crushed. For an underground line, glue-on flexible PVC or PE are safer.

How to connect PE to PVC?

With a suitable transition fitting, or a flexible rubber sleeve tightened with stainless steel clamps when the outside diameters match.

Leave a comment

Le matériel cité dans cet article

Les produits dont nous parlons, en un coup d'œil. Une question ? Notre équipe vous répond au 010 86 03 54.

Aquishop is Aquiflor

Visit us in Nodebais

Behind Aquishop is Aquiflor, a water-garden centre in Nodebais, Belgium. Come and see the equipment running and ask our team for advice, in store or by phone.

AddressAquiflor
22 Rue de la Liberté
1320 Nodebais (Belgium)

Opening hours (low season)Tuesday to Friday: 10am – 6pm
Saturday: 10am – 1pm

  • 5,000 m²of gardens and showroom
  • 20demonstration ponds
  • 20people at your service
  • Official workshoprepairs for Oase, Secoh and other brands
  • Free water testing on site
  • Free in-store pickup of your order